Motorola radio programming grand rapids how to#
Motorola radio programming grand rapids code#

The call tone is factory set to 0 (turned off) but you can change the setting to a preferred call tone. You can set your radio to transmit call tones to other radios in your group to alert them especially if you want to transmit.

Press and hold Push to talk button to exit programming or MENU to continue programming.

(note that the radio retains settings for the channels made unavailable, therefore you can go to the settings and make them available anytime you want to.

Press (-) or (+) to select the number of available channels you want.

Press MENU until CH displays and the channel number flashes.

You can reduce the number of channels on your radio if you need fewer channels.

Press and hold the PTT button to exit programming or MENU to continue programming.

Motorola radio programming grand rapids code#

Press MENU until CODE displays and the code number flashes.If not, press down the Push to Talk button and MON together until you see the PROG sign on the display.

Motorola radio programming grand rapids how to#

To program the code, IвЂ™m sure by now you know how to enter the programming mode. The interference eliminator code helps provides you with codes that filter out static, noise or unwanted messages thus minimizing interference on your walkie-talkie either while transmitting, receiving or on standby. Programming the interference Eliminator code

Press the Push to Talk to exit programming or press MENU to continue programming. To program in the frequency 1, in programming mode, press MENU intil 1 displays and the frequency number flashes 2. Press and hold Push to Talk (PTT) to exit programming mode or press MENU to continue programming.

Press (-) or (+) to select the channel 3.

(note that channel selection is the first setting after you enter the programming mode.)

While in programming mode, press MENU until the channel number flashes and the frequency and code display off and on.

In a simpler way, push down the push to talk (PTT) button together with the button underneath it firmly, and turn the radio on, it gives a beep sound with a flashing green light. The channel number flashes on the display, the frequency (indicated by FREQ) and code (indicated by CODE) will alternately display.Д®nsure that you hold down the PTT button when programming, if you press and release the PTT button during programming, it takes you back to the program page thereby losing all what you have programmed.

The radio will make a beep sound and display the PROG sign. Press and hold the Push to Talk (PTT) and MON button for 3 seconds while turning on the radio. To enter the programming mode on your device, make sure your radio is fully charged. Microphone gain at frequency 2 (medium sensitivity).

Operating frequency configuration (from a pre-programmed frequency list)Д«y default, your Motorola radio is programmed to these settings Д¬hannel 1- 8 each with its corresponding frequency from 1-8.

The programmable settings on your walkie-talkie include Your Motorola radio programming mode allows you to change some settings while others are left unchanged as they are non-programmable.